Legion
-
Bonnet - S/S, 1-1/2"
Part No. PD45846
$96.19- Bonnet
- Stainless Steel
- For 1-1/2" kettle draw off valve
-
BONNET, FAUCET GLAND
Part No. PDG10838
$130.62- Faucet gland
- Bonnet - Stainless Steel
- Replacement Part for 2" valve
-
BONNET, S/S - for 1.5" VALVE
Part No. PD117913
$96.19- Bonnet
- For 1.5" draw off valve
- Stainless Steel
-
-
CERAMIC TILE (5 3/16 X 3 5/8)
Part No. PD43566
$60.55- CERAMIC TILE
- Infrared burner tile
- 5-3/16 X 3-5/8"
-
-
-
-
Contactor - 3 Pole 208/240V
Part No. PDG11354
$63.67- Hartland Contactor
- 208V/240V Coil
- 40 AMP Inductive
- 50 AMP resistive
- 3 Pole
- Commonly used on various Legion models such as KETTLE and only where part is applicable.
-
Contactor, 208/240V, 3 Pole, 75A
Part No. PDG10832
$226.31- Contactor
- 3 Poles
- Coil 208-240V
- Inductive Rating 75 Amp
- Resistive Rating 93 Amp
- 1/4" male terminals
- 2 screw terminals
- 2-1/4" x 4-1/4" centers
- 3-1/2" Width
- 5-1/8" Height
- 4-3/4" Depth
-
Conversion Kit, Natural to LP gas
Part No. PD46421
$23.11- Conversion Kit For Safety Valve
- Nat to LP gas
-
Draw-Off Valve, 3" S/S
Part No. PDG10841
$1,338.62- Kettle Draw-Off Valve
- 3" Stainless Steel
- These Valves must be brazed to unit.
-
-
FLAME SENSOR
Part No. PD38834
$136.13- FLAME SENSOR
- COMMONLY USED ON LEGION MODELS: TGSE-2430-9 AND WHERE APPLICABLE
-
FLAME SENSOR WIRING HARNESS
Part No. PD38835
$171.52- Used on various Legion models such as: TGSE-2430-9 and where part is applicable
-
GEAR ASSEMBLY
Part No. PD44006
$2,263.39- Used on various Legion models such as TWU-20, and where part is applicable.
-
GEAR, PITCH(TRUNNION)
Part No. PD51337
$548.06- Pitch Gear for Trunnion
- OD 7-7/8"
- ID for Center Hole is 1-5/8"
- Used on various Legion models such as TWU-20 and where part is applicable.
-
HANDLE, DRAW OFF VALVE, METAL
Part No. PD61439
$83.70- Handle
-
Commonly used on various Legion Industries models where part is applicable
-
HANDLE, S/S - FOR 3" DRAW OFF FAUCET
Part No. PD117851
$199.12- Stainless steel handle for draw off faucet valve
- For 3" draw off valve
- Used on kettles
-
Heater, Strip 208 Volt
Part No. PD41744
$473.96- Element
- 208 Volts
- 850 Watts
- Commonly used on ;Legion models: and where applicable.
Hex Nut - S/S
Part No. PDG10842
$62.61- Hex Nut
- Stainless Steel
- For 1/12" stainless steel draw off valve
HOSE, SPRAY 48"
Part No. PD61441
$597.71- 48" Spray Hose
-
Commonly used on various Legions Industries models where part is applicable
Ignition Module, 24V
Part No. PDG10830
$275.68- Ignition Module
- 24V
- 1 MV, 2 MV/PV, 3 PV, 4 GND (BURNER), 5 24V (GND), 6 24V, 9 SPARK, 90 SEC
- Old style gray no longer available.
- Spark connection on top.
- Always recommended to replace spark wire when replacing box.
Kettle Draw-Off - 1-12" S/S (No Threads)
Part No. PDG10840
$437.96- Kettle Draw-Off - 1-1/2" Stainless Steel (No Threads)
- This Valve must be brazed to unit.
Kettle Draw-Off - 2" S/S, No Handwheel
Part No. PDG10839
$1,005.60- Kettle Draw-Off Valve
- 2" Stainless Steel
- No handwheel
- These Valves must be brazed to unit.
Knob - Black Plastic, 5/16" hole
Part No. PD13267
$91.00- 3" Black Handle, new style
- for Draw-off valve.
- .312 Square hole, 5/16"
- Use for 1-1/2" valve, PD117918 & 2" valve, PD117917
- Use for T-190 & T-191
LIGHT, SIGNAL - AMBER ROUND
Part No. PD45987
$8.25- Indicator Light
- 250 Volt
- Color Amber
- 1/3 watt
- Mount Size 1/2" Diameter.
- Terminal Size 3/16"
NUT, ACORN, FOR 3" VALVE
Part No. PD117801
$30.00- Acorn Nut
- Stainless steel
- For 3" kettle draw off valve
NUT, HEX - S/S - FOR 2 in. VALVE
Part No. PD117900
$55.52- Hex Nut
- For 2" draw off valve
- Stainless Steel
O-RING FOR 3" VALVE STEM
Part No. PD117710
$7.65- "O" Ring
- 3/4 ID x 1/8" thick
- For 3" draw off valve stem
Pilot Burner, Ignitor sensor NG
Part No. PD54387
$174.49- Pilot burner
- NG
- With sensor and ignitor
- Used on various Legion Industry models such as CSG SKG series where part is applicable
PILOT LIGHT, 250V RED
Part No. PD46159
$23.22- Pilot Light
- Red
- Dome head top
- 250V
- 10" Wire leads
- Fastener lock tabs
- Fits 1/2" diameter hole
- Flat on side
Probe, Electronic Controller
Part No. PD54386
$147.26- Probe
- Push Terminal
- Tan wires
- Used on various Legion Industry models such as CSG SKG series where part is applicable
Relay 115V LWCO, RETRO
Part No. PDG10835
$645.60- This is the retro LWCO relay
- Oem no longer offers this control.
- 12VAC
- Sensitivity 50 K
- Contact design 1 normally open and 1 normally closed (non-powered)
- 10 amp resistive 1/3 HP
- Warrick
- Spade connections
- 3 hole mount
- UL 353 for use in boilers
- Used on various Legion models.
Signal Light - Red, Round, 250V
Part No. PD53449
$9.00- Signal Light
- Red
- Round
- 250V
- Tab Terminal
- Mount Size 1/2" Dia.
- Terminal Size 3/16"
- Used on various Legion Kettles where part is applicable.
Steam Safety Valve - 3/4" NPT, Chrome
Part No. PD13264
$331.65- Steam Safety Valve - 3/4" NPT, Chrome
- 30 PSI
- 550 Lbs/Hr
Steam Safety Valve - 3/4" NPT, Chrome
Part No. PDG10836
$235.85- Steam Safety Valve - 3/4" NPT, Chrome
- 40 PSI
- 675 Lbs/Hr
Steam Safety Valve - 3/4" NPT, Chrome
Part No. PDG10837
$327.21- Steam Safety Valve - 3/4" NPT, Chrome
- 45 PSI
- 740 Lbs/Hr
Steam Safety Valve - 3/4" NPT, Chrome
Part No. PDG11353
$375.87- Steam Safety Valve - 3/4" NPT, Chrome
- 50 PSI
- 625 Lbs/Hr
STEM, DRAW OFF 2", S/S
Part No. PD61440
$530.61- 2" Stem
- Use for 2" kettle draw off valve
- Stainless steel
- Comes with o-ring and nut
- 10-24 threads
- Commonly used on various Legion Industries models where part is applicable.
STEM, S/S - for Draw Off Valve, 1-1/2"
Part No. PDG11491
$121.50- Original Design Draw-off valve stem
- Black head
- Stainless steel
- 10-24 threads at end of the stem
- 0.3" square knob mount
- For 1-1/2" valve
- DuPont Viton Elastomer Coated
STEM, S/S VALVE, 2" (non foodgrade)
Part No. PD117897
$213.41- Faucet Stem
- 6" Long
- Stainless steel
- For 2" draw off faucet valve
- This white head is not foodgrade
- For Groen models: AH-20, AH-40, AH-60, AH-80, D20, D40, D60, DEE/20, DEE/4, DEE/40, DEE/60, DL20, DL40, DL60, DL80, DLT20, DLT40, DLT60, DLT80, DT20, DT40, EE-100, EE-20, EE-40, EE-60, EE-80, FT, MW/D, MW/DT, MW/FT, PT and where part is applicable.
Note: White plunger stem models are not approved for food grade. Our black head stem plunger is.
Stem, S/S, for 3" Valve
Part No. PDG11490
$521.24- Stem
- Stainless Steel
- Comes with O Ring and Acorn Nut
- Original black rubber head model
- DuPont Viton Elastomer Coated
- For 3" steam jacketed kettle faucets
- Used on various Legion models such as KETTLE and only where part is applicable.
THERMOSTAT D1 with Knob
Part No. PD24032
$159.46- Comes with Knob
- Used on various Legion models such as: TGSG2430-9 and where part is applicable.
THERMOSTAT RETRO KIT
Part No. PD24035
$147.26- Thermostat Retro Kit
- Spade terminals
- Capillary & bulb
- No dial
- Use where part is applicable.
Thermostat, Electronic Primary
Part No. PD54385
$297.00- Electronic Temperature Control
- Primary
- Black Box
- 7 terminals
- Used on various Legion Industry models such as CSG SKG series where part is applicable
Wing Nut - S/S
Part No. PD13266
$5.87- Wing Nut
- Stainless Steel
- 10-24 thread
- Use for 1-1/2 & 2" draw off valve stems
WORM GEAR
Part No. PD50730
$297.00- Worm Gear
- Commonly used on Legion models: TWT-80 and where part is applicable.