Ovens & Ranges
-
-
BJWA Thermostat - 250-500F
Part No. PDG10022
$276.37- BJWA Thermostat
- Low-500° F
- 1/4" NPT
- 3/16 x 11-13/16" bulb
- Rotation 0 degrees
- With by pass adjust at top & gas inlet down
- Use for Range - Oven Section
-
BURNER ASSEMBLY, 3 RING
Part No. PD127231
$405.77- Dynamic Cooking System
- 3 Ring Burner Assy
- Use for Range: Stock Pot/Tampura Wok
-
Burner Head
Part No. PD127230
$112.31- Burner Head
- Cast Iron
- Use for Range Top
- 6-1/4" OD including mounting ear
- 6" diameter
- 8 sided
- 4-1/8" burn
- Bolt holes for mounting 2" centers, not threaded
- Has round pin (.470 diameter) & raised slot on bottom
-
-
-
BURNER, ALUMINIZED STEEL
Part No. PD127172
$98.03- Aluminized Steel Burner
- 20-1/4", w/Air Shutter
- Use for Broiler/Griddle Combo; Oven: Range-Oven Section
- For commercial models only
-
-
-
Dial Kit
Part No. PDG11261
$41.82- Dial Kit
- (For thermostat part number PD113961)
- 2" diameter
- For BJ style thermostat
- Off-low-250-500
- Mount 11/16"
- Position D
- 1-3/16" protrusion
- Use for Range-Oven Section
-
Duck Jet Burner Assembly - Nat
Part No. PDG10033
$271.13- Duck Jet Nat Burner
- 7 3/4" diameter
- 18 duck jets
- 1/2" FPT inlet
- #56 size orifice
- Cast Iron
- 125,000 BTU
- Used on various Dynamic Cooking Systems such as ICRA, ISP-J and only where part is applicable.
-
-
-
Gasket, Burner head
Part No. PD43032
$8.45- Burner Head Gasket
- 3-5/8" x 1-1/8"
- Fiber gasket
- Type C
- Gray
- 2" center mount holes
-
K Thermostat - 140-500F
Part No. PDG10025
$142.20- K Thermostat
- Range 140-500° F
- Bulb 3/16 x 11-5/8"
- Capillary 36"
- Use for model FSCO
-
KNOB KIT, BJ - LO-500
Part No. PD45915
$30.30- OFF-LOW-250-500° F
- With 4 Way D-Stem Insert adapter
- 2" diameter
- Mount .240
- Use on BJ Series (Ovens)
-
KNOB, BJ - LO-500
Part No. PD46814
$19.80- Dial Only
- OFF-LOW-250-500° F
- 2" diameter
- Mount .240
- Use on BJ Series (Ovens)
-
Micro Leaf Switch - Door
Part No. PDG10030
$96.64- Micro Leaf Switch - Door
- 1HP - 125V, 2HP - 250V
- 3 screw terminals
- Positions On/Off
- 1" hole centers
- Used on various Dynamic Cooking Systems and only where part is applicable.
-
MODULE ASSY, IGNITION CONTROL
Part No. PD128265
$343.64- Ignition Control Module Assembly
- Includes
- cover plate
- gasket
- Spark cable
- Wire Harness
- pilot ignitor
- Used on various Dynamic cooking System models such as FSCO and only where part is applicable.
-
Momentary On/Off Rocker - Motor
Part No. PDG11263
$57.09- Momentary On/Off Rocker - Motor
- Use for FSCO
-
On/Off Handle (For PD114053)
Part No. PDG10019
$34.26- On/Off Handle (For PD114053)
- Use for Jet Stock Pot/Jet Wok
-
On/Off Knob, Burner, Chrome
Part No. PD127076
$23.09- On/Off Knob
- Chrome Burner Valve Knob
- 2-1/2" diameter
- Mount .24
- D Stem flat up
- 3/8 Protrusion
- Use for Various Dynamic Cooking Systems models such as FSCO, Char Rock Broiler, Broiler-Griddle combo, Tempura Wok where part is applicable. Not for cheesemelter salkamander, use
-
-
On/Off/On Rocker with Red Lights - Power
Part No. PDG10045
$67.07- Rocker switch with Red Lights
- (4) 1/4" tab terminals; 3 on one side, one middle
- Fits hole 1-5/8" x 3/4"
- SPDT (ctr off)
- On-Off-On positions
- 10A-250V, 15A-125V
- Used on various Dynamic Cooking Systems models and only where part is applicable.
-
ORIFICE W/#51 HOLE
Part No. PD38521
$26.19- Burner Orifice
- # 51 drill opening hole
- 1/4" MPT x 1-3/4" length
- Brass
-
Oven Rack 26" with Back Stop
Part No. PD26478
$194.12- Oven Rack
- Nickel plated
- 26 x 17-15/16" with back stop wire
- Back stop is 1-1/4" to top of frame
- 5/16" frame
- 1 support
- 17 cross wires with 1-1/2" spacing
- Used on various DCS models only where part is applicable.
-
Pilot Adjustment Valve
Part No. PDG10040
$20.05- Pilot Adjustment Valve
- Use for Jet Stock Pot/Jet Wok, Range Top, Stock Pot/Tempura Wok
-
Pilot Burner with Electrode - Nat/LP
Part No. PDG11258
$86.57- Pilot Burner
- with Electrode
- with ignition cable
- Nat/LP gas
- 1/4" CCT
- .018 orifice
- 3/16" push on end of wire
- Used on various Dynamic Cooking Systems models and only where part is applicable.
-
PILOT KIT 1/4 NG/LP
Part No. PD55067
$92.70- Gas Type Nat/LP
- Size 1/4" CCT
- Hood width: 1 1/2"
- Flame pattern 3 way
- Used on various Dynamic Cooking System models such as DCSF8F-40N and only where part is applicable.
-
Pilot Tip - 3/16" Connection
Part No. PDG10021
$25.79- Pilot Tip - 3/16" Connection
- Use for Stock Pot/Tempura Wok
-
Pressure Regulator -3/4", Nat
Part No. PD43205
$38.39- Pressure Regulator
- Natural gas
- 3/4 inch FPT Gas In/out
- Inlet pressure: 1/2 PSIG
- Outlet pressure: 3.0" - 6.0" wc
- 250,000 BTU capacity
- Maxitrol RV48L-66-0001 preset at factory to 3.5
- Used on various Dynamic Cooking Systems models and only where part is applicable.
-
SAFETY VALVE, GAS
Part No. PD30011
$159.99- TS11 Safety Valve
- 1/4" FPT x 1/4" pilot in & out
- Used on various Wolf/Vulcan models such as C34S, C23S, CHR, and where part is applicable.
-
SOLENOID VALVE, GAS
Part No. PD43513
$141.49- Gas Solenoid Valve
- 120V
- 3/8" NPT in & out
- 121,000BTU
- 1/8" pilot out
- This is the new style with black molded coil
- Used on various DCS model FSCO and where part is applicable
-
-
Thermocouple - 18", 1980 series
Part No. PDG10037
$27.43- Thermocouple
- Snap-fit
- 18" long
- Robertshaw
- 20-30MV
- 1980 series
- Commonly used on DCS commercial ovens only
-
Thermocouple - 72"
Part No. PDG11260
$49.61- Thermocouple
- 72"
- Snap-fit
- Adapter for closed circuit test of thermocouples using a suitable millivolt test meter.
-
THERMOPILE
Part No. PD55066
$63.00- Thermopile
- 36" Coaxial
- 250-750 MV
- Threads 3/8" - 32
- Use on various Dynamic Cooking System models such as: DCS FSF-40N and where part is applicable.
-
TS Safety Valve
Part No. PDG10020
$159.99- Safety Valve
- Natural or LP gas
- Magnet head and gas carrier
- Gas IN/Out 1/4" FPT
- J Type pilot in/out 1/4" CCT
- Width 3-1/2"
- Robertshaw
- Use for Range-Oven Section
-
Universal pilot tubing with head, 3/16"
Part No. PD17872
$28.97- 3/16" tube x 24" long with pilot head
- Bend & shape to your needs
- Copper tubing
- With compression nut and ferrule
- Natural or LP gas
- Used on various Dyanmic Cooking Systems DCS models such as where part is applicable
-
Valve, Gas on/off
Part No. PDG10024
$37.08- On/Off Gas Valve
- 1/8" MPT x 3/8"-27
- Rotation On/Off
- Center inlet to end of stem is 2-1/8"
- 90 Degree angle
- Stem length 1-1/4"
- 7/8"
- 2-1/4"
- Use for Range Top, Stock Pot/Tempura Wok
-